4) You will need to have on hand local plumber tape, small gas torch, solder, flux, plumbing sandpaper, pipe cutter, gas tape (to seal gas line) and maybe some pipe glue. Ask the sales person at the hardware store for a more defined list.
When you get to the house stand if front of the toilet and locate the water shut off valve. Should be down below the toilet on the wall. Just turn it off (righty-tighty) completely and flush the toilet. All the water should have left the tank, well at least most of it. If there is remaining water line repair get it out with paper towels or a rag. The important thing is that no more water came in. If it did then your valve is not shut all the way or not working and you need additional help.
One other common design that is considered "washerless" was made famous by Delta and copied by several other makers. It uses little "cup" seals that fit over springs recessed in the back of the valve body. The springs press these "seals" against the cartridge and regulate the flow through little tapered openings in the cartridge. If you have one of these and it's dripping, changing these springs and seals will usually correct it. Here's a tip. Once you have the cartridge out of the way, insert a phillips screwdriver into the seal and pop both the seal and spring out. Stick the new ones on the end of the screwdriver to help guide them into place. This is especially helpful if you don't have long slender fingers.
Dishwasher. To check water leakage on your dishwasher, you will need several sheets of paper placed underneath the machine before operating it. When the machine stops, check the sheets of paper you placed underneath to see it they are wet. If so, call a maintenance person to repair the leak immediately. It is important also for you to remember that regular dishwasher uses 15 gallons on every wash load. Make sure that when you use it, the load is full.
The first step in the replacement project is to turn off the water line repair to the toilet and flush any water that may be in the tank. If you forget this step, you will have a giant mess to clean up! You should now disconnect that water line.
The way a toilet plunger works is by filling up with water and then pushing that water through the stopped up drain. When unclogging a clogged toilet, the idea is to plunge up and down a couple of times so the plunger fills with water and then jam the open end, sometimes called a force cone, into the waste outlet in the plugged toilet and start plunging. You may have to pump the plunger up and down several times to clear the blockage.
The next huge thing is to prevent and kill mold that has already started growing. Mold is the most dangerous thing when an area floods. Mold can turn deadly within a extended period of time. Use mold killing agents like Killz and other products on the the market. Be extremely thorough with this process. If the water flooded above the dry wall line, you MUST remove the dry wall to make sure you can replace insulation and dry wall which mold naturally is attracted to. Painting a Killz primer on the concrete is a great idea before installing new carpet and drywall. This will ensure that you have prevented future mold growth and will also ensure the safety of your family.